1.A connecting hyperlink of an O-ring Chain for standard application is pre-coated with grease with the pins. Ahead of connection, verify the grease around the surfaces of pins, and in case the volume of grease is smaller, apply grease with bare hands. (If gloves are made use of, the grease will likely be absorbed by the gloves.)
Illustration: Once the connecting hyperlink (I) of an O-ring chain for standard application is
shipped, O-rings are fitted at the roots of the pins. Should the O-rings come loose on account of vibration through transport, refit the O-rings in on the roots with the pins.
In this instance, make sure to return the grease collected in the roots on the pins to the central surfaces in the pins, a lot more at portion A than at portions B proven from the over illustration. (Portions A is worn on account of sliding with the bushings.)
2.The chain may be most conveniently linked about the teeth of a sprocket. Engage the backlinks at the two ends of your chain together with the sprocket teeth and match connecting pins. If your sprocket may be moved, the chain can also be linked over the loosened side.
3. Connecting method
1.Verify that O-rings are attached for the roots of the pins.
two.If your level of grease applied to the connecting pins is small, coat the pins with grease with the central portions.
3.Insert the connecting pins into the bushings of the inner hyperlinks at each ends.
four.Confirm that the grease is applied on the complete face from the O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins into the connecting plate and although pressing the connecting plate, install the spring clip. Verify no matter if the head (the finish with no split) of your spring clip is turned while in the feeding route of your chain. (See the following illustration.)
six.Be sure you verify the spring clip is securely fitted from the clip grooves with the connecting pins.
This completes jointing of the connecting website link. Note that grease around the surfaces of connecting pins and O-rings may be eliminated through installation do the job. In this instance, re-grease applying the grease around the surface of your base chain or even the grease while in the polyethylene bag during which the connecting link was contained.