The EP Greenhouse gear reducer is a concise and lightweight reduction geared motor with an integrated limit switch system that’s suitable for assembly of a locally available electric engine. The geared motor is utilized in manually-managed or climate-controlled ventilation and display screen systems in greenhouses. The quick and easy-to-install EP reducer can be rainproof and windproof. The geared motor includes a high protection class (IP65) and can be used in an ambient temperature of 0-60 °C.

The low-noise gearbox for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated within an aluminum precision housing. The self-braking worm wheel transmitting means that the drive shaft is usually locked when the reduction gear reducer isn’t running. The completely sealed reduction gear motor has an expansion chamber with a diaphragm to keep the gear essential oil at a minimal pressure under all conditions, even at high temperatures. Thanks to the use of an expansion chamber, the geared motor can be installed in any placement. There are no limitations, since there is no need for a bleed connect. The sealed reduction reducer keeps the gear oil of the geared motor in optimum condition for its entire operating lifetime. The gear reducer is suitable for discontinuous use, operating course s3-30%, with a maximum activation time of 25 minutes.

The Gear box reduction gear motor has an FT85 motor assembly flange, on to which a suitable IEC standard motor can easily be installed (EN 50347).

The Gear box has a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off by the end positions. The limit change system is installed in an built-in chamber and is certainly enclosed by an impact-resistant plastic cover. The limit change system is accessible and simple to adjust. The limit change system’s maximum switching range is 40 or 64 revolutions of the drive shaft. The cabling is connected in spring-clip connections. The geared motor has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.

The gear motor for greenhouse includes 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates are available as accessories.

Optimum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of program of 4-pole electric motor.
Protection class IP65.
May be used in ambient temperature ranges of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, optimum activation time 25 mins.
Equipped as regular with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC regular motor (EN 50347).
Maximum switching selection of limit switch program 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).